for people who owned Polar Power Sensors please read.

andyanansu

Hi

I own a Polar Bike Power Sensor.

Just this morning, as I was preparing my bike for a ride, I was
pulling the sensor cable out of the bar mount. But the cable
accidentally stripped off from the plastic housing, (the copper wire
broke off from the solder)

I'm now planning to solder the wires back in, but I got a problem,
I'm not sure which colour of wire goes to which, as the 3 wires come
off at once!

I need you guys to have a look at your cable and tell me which goes
where. All you need to do is to have a look at cables inside the
housing, there are 3 colours, Red, Blue and Green.

You can unscrew the cable housing by turning it anti-clockwise.

Also an advice for you all, when you pull the cable out, don't grab
the black cable, pull the cable housing instead, otherwise, you might
damage the inside.

Need you helps urgently, or if you know your friend have one, can you
please pass this email to them for me?

Many Thanks

Andy

andyanansu

Come on peoples, 57 views and no reply?

I'm trying to fix this before the weekend ride.

Please help, Urgently!

Many Thanks.

Andy

Tom Anhalt

I can look at mine this evening. Patience

andyanansu

Thanks Tom, eagerly waiting...

Andy

Tom Anhalt

Oops....my apologies. I've been sick in bed with a cough/cold all day and I totally forgot you needed that. Here it is:

Looking at the rear of the connector (i.e. the part where the wires are soldered), with the large "keying" slot downward, it's blue on the lower left, red on the top/middle, green on the lower right.

Here's my quick and dirty MSPaint diagram: