Flat:Split seam










PDA

About Cycling Forums
Flat:Split seam
Since 2001, over 90,000 cyclist's have joined Cycling Forums to discuss topics from general cycling to equipment, training, racing and travel or vacation destinations (especially in europe during the tour de france). We also feature an great deals in our online store, 100's of articles, classifieds and product reviews.

View Full Version : Flat:Split seam



The content of the Flat:Split seam article is:

OldNickToo
Flat:Split seam
I am using kenda 1.95 tubes in a 2.25 tyre. I was told this was OK. The tyres are rated at 40-60 PSI. I am running the rear at 40 and the front at 30-35. NO problems...until this morning.

I checked pressure front and rear and went for a moderate ride....but bumpy.

Suddenly that unwritable sort of "wubbling" sound, followed by unprintable words spoken.

Flat.

I re-pumped, and checked to see it was not just the valve from when I had pumped up earlier.....nah!

I was not far from home so rather than repair in the rain on the wet leaves, I walked back home.

The tube has split on the seam next to the rim tape. There is no sign of wear, or puncture. The seam has simply opened up over a length of about 1/2-3/4 inch (12-20 mm). It does not even show until you either pump up the tube quite a bit, or pull it apart.

I have repaired it to see what happens.

Crappy tube (stock with bike)?
Tube too small?
Shit happens?

Thanks for any advice.

gclark8
Flat:Split seam
You used a KENDA!! :eek:

Nic, go the extra $ and get Conti with presta valves. :)

If you want some cheap tyres and tubes come and see me. :D http://perthmtb.com//modules.php?name=Forums&file=viewtopic&t=1605 Some of these are off new bikes.

OldNickToo
Flat:Split seam
You used a KENDA!! :eek:

Nic, go the extra $ and get Conti with presta valves. :)

If you want some cheap tyres and tubes come and see me. :D http://perthmtb.com//modules.php?name=Forums&file=viewtopic&t=1605 Some of these are off new bikes.
OK. Crappy tube then :)

I didn't exactly _use_ it. I simply _re_used it :) It was on the bike.

However I take your point. I have spares (not Conti. I will check that out) that certainly look better on the seams, with a slight ridge, where the Kenda has a simple butt joint.

Anyway, apart from the bad reuse of the Kenda, it's nothing I have done.

Most unfair. It was such a good ride and I was just getting rid of a bit of steam! Bah!:(





cyclingforums.com | home | WWF | Wine
Website and eCommerce Solutions